Idle monster td tech guide
![idle monster td tech guide idle monster td tech guide](https://img.youtube.com/vi/rPyU706gF_U/0.jpg)
It may be very close but if there is something that you can't see, the gauge will tell you how much air is actually passing through each carb. You're done! The world is in harmony.īefore when I nailed it, the rear butterflys would hit their stops at WOT and not allow the front butterflys to open all the way so synchronizing can affect all out performance.Ĭlick to expand.That's the best you can do without out a gauge. When it's purring like a kitten and both carbs are still flowing the same cfm, bring the loose idle speed screw back up until it starts to make contact. If the idle picks up with the mixture screw adjustment, back it down with the one working idle speed screw. You can also play with the idle mixture screws now. With the link now hooked back up one carb speed screw will move both carb butterflys. If it's still idleing too fast, back off one of the idle speed adjusting screws a few turns to disable it and adjust the idle speed of both carbs with the other carb's idle speed screw. Now both carbs are reading just below 8.synchronized. The engine still may be idleing too high. Once both carbs are flowing the same amount, you can lock down the link tying them together. I'm just trying to get the same gauge reading on both carbs.
![idle monster td tech guide idle monster td tech guide](https://www.gamepretty.com/wp-content/uploads/2020/12/maxresdefault-2020-12-08T094955.750.jpg)
I'm not worried about idle speed at this time. I adjusted the front until the gauge started to show some air flow. There was no way of knowing that without the gauge. It's idleing fine but only through the rear carb. As the air volume increases the vane moves farther up the scale. (red line between the numbers) The red line is actually the edge of a moveable vane or flapper. If you learn on a Uni-syn, that's what you'll be true to. The first thing to do is to loosen the link between the carbs so that each carb can be adjusted independently. You'll just repeat the same steps a lot more. The steps will be the same if you are syncing 2, 4, 6 or 8 carbs. This will be boring to many but if it helps a few that are just getting started, I'll be pleased. I know I know The copper fuel line will be replaced!!!